Mitsubishi Сolt fault electronics error U1108 repair on-Board computer
It all works fine now. Пока больше не зависает.
If the diagnosis code No. U is set to the ETACS-ECU, always diagnose the CAN…
Сегодня утром включил авто, чекэнджи не горит, все гуд. Потом поменял телефон, скачал опять прогу эту и подключился. I brought the display into the workshop, where repair mobile phones.
Авторизуйтесь для ответа в теме. Если логически поразмыслить, то все на плохой контакт говорит.
Also, power steering failed or was interrupted suddenly. Very tricky to drive. The outside temperature reading missed most of the time.
The day-time clock indicated not the actual time, the time fluctuated, as well as the indication of the fuel comsumption. Even the intensity of the interior light fluctuated, irregulair. Whilst searching I found an other site https: Secondly I viewed your site, same troubles as you discribe, I experienced. I de-assembled the mid-display. I have a heat gun for re-fluxing and some flux paste.
The flux paste kept all solder in position as it became gently fluid.
Расшифровка кодов диагностики OBDII/EOBD
Resoldering went perfect that way. I noticed that some print layer-tracks must have contact to other track on the opposite site of the bord, conneting via holes in the board.
I put flux on the several holes and added just a tiny litle bit of solder. I managed perfectly to resolder the connections of the top and bottom board tracks.
ошибки U1108 U1110 U1073
After re-assembling, testing for 8 days now I can say: It all works fine now. Whilst searching I found an other site https: Secondly I viewed your site, same troubles as you discribe, I experienced.
I de-assembled the mid-display. I have a heat gun for re-fluxing and some flux paste. The flux paste kept all solder in position as it became gently fluid.
Resoldering went perfect that way. I noticed that some print layer-tracks must have contact to other track on the opposite site of the bord, conneting via holes in the board. I put flux on the several holes and added just a tiny litle bit of solder. I managed perfectly to resolder the connections of the top and bottom board tracks. After re-assembling, testing for 8 days now I can say: It all works fine now.
I now even hear a beep for acceptation -never before! The display even shows better fuel consumption rates, stable.
Obviously no noise on the CAN-system. If the diagnosis code No.
Появились ошибки U , потеря последовательной связи устройств класса это обозначает? Доброе время суток, эти U , ошибки не Кольта, коды должны быть.
Add Your Answer
Привет всем помогите пожалуйста. Ошибки u — — — что делать? Машина делика д5 только пришла с японии.
И в ней блок etacs менен. Куплю, Продам, Шины, Колеса.
На горящий чек об яснили низкокачественным бензином. Что-то в цепи не так.
MITSUBISHI COLT multivizion display miles or kilometres
Outlander — Технические характеристики. Потом поменял телефон, скачал опять прогу эту и подключился.
